Dansons Group CC3 Guía de instalación descargar pdf (Pagina 3)

COMPLETE THIS CHECKLIST PRIOR TO INSTALLING YOUR PELLET APPLIANCE:

Unless you are knowledgeable and experienced in stove installation, we recommend your stove receive

a pre-delivery check and be installaed by your local specialty retailer or certified HVAC service depot.

Carefully read this INSTALLATION GUIDE. SAVE THIS GUIDE FOR FUTURE USE!

COMPLETE THIS CHECKLIST WHILE INSTALLING YOUR PELLET APPLIANCE:

Determine the location and measurement needed for your chosen location.

Be sure to pre-fit all items before you fasten or install the stove or venting permanently.

IMPORTANT: Use ONLY L or PL type venting for your venting installation, or stainless

steel liner for existing chimney configurations. Do NOT use plastic piping!

Ensure ALL joints of L vent, PL vent and/or single wall stainless steel liner are tightly connected,

sealed with RTV silicone (including exhaust connector) and is correctly installed. Follow the vent

manufacturer’s instructions.

Verify that the stove is plugged into a 3 pronged grounded outlet, NON GFI (ground fault interruptor)

NOTE: We STRONGLY recommend the use of a surge protector to protect the circuitry in your

control board.

For outside air, use metal pipe ONLY, either solid or flexible. PVC or any other non-metallic

material MUST NOT BE USED.

For more information regarding pellet stove operations or other specifications, please read your

OPERATIONS GUIDE included with the stove. That guide, along with this INSTALLATION GUIDE, are

available online at www.dansons.com/support.

Have your local Dealer demonstrate all operational, cleaning & maintenance steps necessary for

your stove.

Installation of this appliance must conform to local codes and applicable state/provincial/federal

requirements. Becoming familiar with these requirements before installation is essential.

Select an install location. The design of your home and placement of the stove will determine its

value as a source of heat. A pellet stove depends primarily on air circulation to disperse its heat.

There are other practical considerations to be considered before final placement is decided:

eg. existing chimneys, pellet fuel storage, aesthetic considerations, roof design (rafter location &

roof pitch), room traffic, clearances to combustibles, existing wiring, heat loss

NOTE: Placing a unit in an uninsulated area greatly reduces heat capability (ie. cement basement,

uninsulated steel building, etc.

INSTALLATION &

PLANNING CHECKLIST

1 2 3 4 5 6 7 8 ... 15 16

Sin comentarios

Dansons Group CC3 Guía de instalación Pagina 3